features: compact 300w with 1u height power density: 8.3 watts/cu in input voltage: 90 - 132 / 180 - 264vac auto - ranging, 47~63hz. input current: 8/4a at 100 - 120/200 - 240vac. inrush current: max. 70a@230vac & 35a@115vac; cold start. pfc: power factor correction pass en61000 - 3 - 2 class a. transient response: returns to within 1% in less than 2.5ms for a 50% load change and the peak transient does not excess 5%. overshoot: turn - on & off overshoot < 5% over nominal voltage. efficiency: 75% ~ 85% depends on model. turn on delay : 1 second maximum at 230 vac. hold up time: 20ms min. at 80% of full load. adjustability : output user adjustable +/ - 5% minimum. fan drive: 12vdc/400ma offering to drive an external fan. fan fail (ff) alarm: designated as ff on pin 3 of cn1, two types of logical signal provided, contact manufacturer. power supply on: green led designated as led1 on the pcb. power good: pg on cn1 goes high 100 - 500ms after dc regulation and low at least 1ms before loss of regulation (open collector). input fusing protection: one t8a/250v fuse inserted in primary. over - power protection: 110~140% of i - max; auto - recovery. short circuit protection: trip without damage and auto - recovery. over voltage protection: unit latching down when output exceed 130% and recycle ac input to reset. over - temperature protection: unit protected of excessive operating ambient 110 , and automatic recovery. switching frequency: 23k hz fixed frequency. operating temperature: 0 to 70 ambient, de - rating at 2.5% per degree from 50 to 70 . storage temperature : - 20 to 85 . storage humidity: 5% to 95% rh, non - condensing. operating humidity : 5% to 90% rh, non - condensing. vibration: 5 ~ 50 hz, acceleration 7.35 m/s*s on x,y and z axis. emc: en55022 class b conducted / radiated, en61000 - 3 - 2, en61000 - 3 - 3; en55024 (iec61000 - 4 - 2, iec61000 - 4 - 3, iec61000 - 4 - 4, iec61000 - 4 - 5, iec61000 - 4 - 6, iec61000 - 4 - 11). safety regulation: ul60950 - 1, en60950 - 1, iec60950 - 1. leakage current: < 1ma @ 264vac. (optional for 500ua max. at 240vac / 300ua max. at 120vac input) hi - pot test : 1500 vac input line to chassis (10ma dc cut off current); isolating 3000vac primary to secondary windings; primary to core 1500vac. all for 3 sec. grounding test: apply 25 a from ground pin of the three prong plug to the far most earth. max allowable resistance 0.1 ohm. warranty: 2 years. mtbf: 100000 hrs (according to mil - hbk - 217f) at 30 . cooling: u type: u - chassis @300w max. with 18cfm airflow or 150w max. convection cooling c type: u - chassis with top cover @150w max. convection cooling e type: enclosed with side built - in fan @300w max. f type: enclosed with top built - in fan @300w max. burn in: 45 +/ - 5 degree c for 1 hour @230vac with full load. enclosure : u type: 6(l) x 4(w) x 1.5(h) inches. c type: 6(l) x 4(w) x 1.55(h) inches. e type: 7(l) x 4(w) x 1.6(h) inches. f type: 6(l) x 4(w) x 2(h)inches. weight : maximum weight is 800g. copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. product specifications: c type: 6(l) x 4(w) x 1.55(h) inches. e type: 7(l) x 4(w) x 1.6(h) inches. f type: 6(l) x 4(w) x 2(h)inches. u type: 6(l) x 4(w) x 1.5(h) inches. cb 125w ~ 300w ac - dc switching power supply rl0601d dual output series ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465
output voltage / current rating chart: measured at output power connector. note: * rl0601d series are designated as rl0601dx - y where x can be u (u - chassis), c (u - chassis with top cover), e (enclosed type with side built - in fan) or f (enclosed type with side built - in fan); y can be 0512, 0524, 0548, 1224 . * rl0601du (with min. 18cfm forced air flow) & rl0601de & rl0601df series: max. 300w total combined power of v1 and v2 for rl0601dx - 1224 and 250w for other models. * rl0601du and rl0601dc series with convection cooling: max. 150w total combined power of v1 and v2 for rl0601dx - 1224 and 125w for other models. * ripple and noise is measured from 10khz to 20mhz bandwidth at output with parallel 0.1f ceramic and 22f electrolytic capa cit ors. * 10% minimum load is required to maintain the ripple and regulation. * output is fully isolated. input and output connector (cn2): terminal block - howder part no. hb - 95 - 7p molex - mating jst vh series. input 5 pin connector (3 pin used, pin 2 & pin 4 removed), pcb labeling: l = line; n = neutral; g = chassis ground. output 10 pin connector. input and o utput connector pin assignment: (see table in right). mounting inserts: 6 places 8 - 32 (m4x0.7 optional). maximum penetration 4mm sees outline drawing for location. logic signal connector (cn1) : mating jst xhp - 3 or equivalent (chyao shiunn js - 2001 - 03); mating pins: jst sxh - 002t - p0.6 for awg 30 to 26. fan driver connector (fan2) : mating connector is jst p/n xhp - 2 (2 pins 0.98 pitch) or equivalent (chyao shiunn js - 2001 - 02). howder molex pin 1: v1 pins 1 ~ 3: v1 pin 2 ~ 3: rtn pins 4 ~ 8: rtn pin 4: v2 pins 9 ~ 10: v2 pin 5: gnd pin 11: gnd pin 6: neutral pin 13: neutral pin 7: line pin 15: line copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. outline drawing: model number output voltage max. output current regulation ripple & noise type u (force air) & e & f type u, c (convection) rl0601dx - 0512 v1:+5v 30a 15a +/ - 5% 1% v2:+12v 16.67a 10.42a +/ - 5% 1% rl0601dx - 0524 v1:+5v 30a 15a +/ - 5% 1% v2:+24v 8.33a 5.2a +/ - 5% 1% rl0601dx - 0548 v1:+5v 30a 15a +/ - 5% 1% v2:+48v 4.16a 2.6a +/ - 5% 1% rl0601dx - 1224 v1:+12v 16.67a 12.5a +/ - 5% 1% v2:+24v 8.33a 6.25a +/ - 5% 1% ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465
rl0601du series (u - chassis type): 6 (l) x 4(w) x 1.5(h) inches; weight: 600g. copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. rl0601dc series (u - chassis with top cover type): 6 (l) x 4(w) x 1.55(h) inches; weight: 650g. ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465 a 4:1 (6x)zn-plated fan2 + - pg rtn ff fan2 + - pg rtn ff pin 1 g n l v1 rtn g n l v2 rtn g n l v1 v2 fan2 + - fan2 + - pg rtn ff pg rtn ff pin 1 a 4:1 (6x)zn-plated g n l v1 rtn g n l v2 rtn g n l v1 v2
copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. rl0601de series (enclosed with side built - in fan type): 7 (l) x 4(w) x 1.6(h) inches; weight: 750g. rl0601d f series (enclosed with top built - in fan type): 6 (l) x 4(w) x 2(h) inches; weight: 800g. ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465 fan2 + - pg rtn ff fan2 + - pg rtn ff pin 1 a 4:1 (6x)zn-plated rtn g n l v1 v2 g n l v1 rtn g n l v2 fan2 + - pg rtn ff fan2 + - pg rtn ff pin 1 a 4:1 (6x)zn-plated g n l v1 rtn g n l v2 rtn g n l v1 v2
|
